Please read through these steps before performing
SD CARDS
Verify you have the correct SD card (The Cellucore cameras are especially particular) :
RESET CAMERA
Turn off the Camera
Pull the SD card and batteries
Wait 30 seconds
Put the camera back together and turn it back on
REFORMAT SD CARD ON COMPUTER
We suggest reformatting new SD cards as well, as they can come from the factory with corrupted files on them.
BATTERIES
Verify you have fresh batteries in the camera. Bushnell suggests Lithium batteries.
ANTENNAS
Check your antenna for any damage, and remove it from the camera. When reattaching, please make sure the connection is clean and dry.
SOLAR PANELS (Cellucore 20- solar only)
The solar panel will be completely dead when it arrives, get it charged for use:
Disconnect the solar panel from the camera.
Set the panel out in the sun for 2 days.
Reconnect to camera
SIM CARD RESET (CELLUCORE V20 and A20 models only)
Similar to the SD card, push on the panel to unseat it.
Pull the SIM card
Use a non-abrasive cloth to wipe down the card.
Blow out the slot, using dry canned air is best
Wait 30 seconds and reseat sim card.
After these steps have been completed, it is a good idea to wait about 24 hours. This gives the camera ample time to connect to the nearest cell service tower. CelluCORE series cameras use available 4G networks (Cameras do not use 5G and connect differently than your personal cell phone, so the signal strength may not be the same)